Experimental analysis and semicontinuous simulation of low-temperature droplet evaporation of multicomponent fuels

Experimental analysis and semicontinuous simulation of low-temperature droplet evaporation of... Low-pollutant and efficient combustion not only in internal combustion engines requires a balanced gaseous mixture of fuel and oxidizer. As fuels may contain several hundred different chemical species with different physicochemical properties as well as defined amounts of biogenic additives, e.g., ethanol, a thorough understanding of liquid fuel droplet evaporation processes is necessary to allow further engine optimization. We have studied the evaporation of fuel droplets at low ambient temperature. A non-uniform temperature distribution inside the droplet was already considered by including a finite thermal conductivity in a one-dimensional radial evaporation model (Rivard and Brüggemann in Chem Eng Sci 65(18):5137–5145, 2010). For a detailed analysis of droplet evaporation, two non-laser-based experimental setups have been developed. They allow a fast and relatively simple but yet precise measurement of diameter decrease and composition change. The first method is based on collecting droplets in a diameter range from 70 to 150 µm by a high-precision scale. A simultaneous evaluation of mass increase is employed for an accurate average diameter value determination. Subsequently, a gas chromatographic analysis of the collected droplets was conducted. In the second experiment, evaporation of even smaller droplets was optically analyzed by a high-speed shadowgraphy/schlieren microscope setup. A detailed analysis of evaporating E85 (ethanol/gasoline in a mass ratio of 85 %/15 %) and surrogate fuel droplets over a wide range of initial droplet diameters and ambient temperatures was conducted. The comparison of experimental and numerical results shows the applicability of the developed model over a large range of diameters and temperatures. http://www.deepdyve.com/assets/images/DeepDyve-Logo-lg.png Experiments in Fluids Springer Journals

Experimental analysis and semicontinuous simulation of low-temperature droplet evaporation of multicomponent fuels

Loading next page...
 
/lp/springer_journal/experimental-analysis-and-semicontinuous-simulation-of-low-temperature-jboge0nuTR
Publisher
Springer Berlin Heidelberg
Copyright
Copyright © 2014 by Springer-Verlag Berlin Heidelberg
Subject
Engineering; Engineering Fluid Dynamics; Fluid- and Aerodynamics; Engineering Thermodynamics, Heat and Mass Transfer
ISSN
0723-4864
eISSN
1432-1114
D.O.I.
10.1007/s00348-014-1871-9
Publisher site
See Article on Publisher Site

Abstract

Low-pollutant and efficient combustion not only in internal combustion engines requires a balanced gaseous mixture of fuel and oxidizer. As fuels may contain several hundred different chemical species with different physicochemical properties as well as defined amounts of biogenic additives, e.g., ethanol, a thorough understanding of liquid fuel droplet evaporation processes is necessary to allow further engine optimization. We have studied the evaporation of fuel droplets at low ambient temperature. A non-uniform temperature distribution inside the droplet was already considered by including a finite thermal conductivity in a one-dimensional radial evaporation model (Rivard and Brüggemann in Chem Eng Sci 65(18):5137–5145, 2010). For a detailed analysis of droplet evaporation, two non-laser-based experimental setups have been developed. They allow a fast and relatively simple but yet precise measurement of diameter decrease and composition change. The first method is based on collecting droplets in a diameter range from 70 to 150 µm by a high-precision scale. A simultaneous evaluation of mass increase is employed for an accurate average diameter value determination. Subsequently, a gas chromatographic analysis of the collected droplets was conducted. In the second experiment, evaporation of even smaller droplets was optically analyzed by a high-speed shadowgraphy/schlieren microscope setup. A detailed analysis of evaporating E85 (ethanol/gasoline in a mass ratio of 85 %/15 %) and surrogate fuel droplets over a wide range of initial droplet diameters and ambient temperatures was conducted. The comparison of experimental and numerical results shows the applicability of the developed model over a large range of diameters and temperatures.

Journal

Experiments in FluidsSpringer Journals

Published: Dec 9, 2014

References

You’re reading a free preview. Subscribe to read the entire article.


DeepDyve is your
personal research library

It’s your single place to instantly
discover and read the research
that matters to you.

Enjoy affordable access to
over 18 million articles from more than
15,000 peer-reviewed journals.

All for just $49/month

Explore the DeepDyve Library

Search

Query the DeepDyve database, plus search all of PubMed and Google Scholar seamlessly

Organize

Save any article or search result from DeepDyve, PubMed, and Google Scholar... all in one place.

Access

Get unlimited, online access to over 18 million full-text articles from more than 15,000 scientific journals.

Your journals are on DeepDyve

Read from thousands of the leading scholarly journals from SpringerNature, Elsevier, Wiley-Blackwell, Oxford University Press and more.

All the latest content is available, no embargo periods.

See the journals in your area

DeepDyve

Freelancer

DeepDyve

Pro

Price

FREE

$49/month
$360/year

Save searches from
Google Scholar,
PubMed

Create lists to
organize your research

Export lists, citations

Read DeepDyve articles

Abstract access only

Unlimited access to over
18 million full-text articles

Print

20 pages / month

PDF Discount

20% off