Get 20M+ Full-Text Papers For Less Than $1.50/day. Start a 14-Day Trial for You or Your Team.

Learn More →

Numerical study of boundary layer transition using intermittency model

Numerical study of boundary layer transition using intermittency model In this paper, the applicability of shear stress transport k-ω model along with the intermittency concept has been investigated over pitching airfoils to capture the laminar separation bubble (LSB) position and the boundary layer transition movement. The effect of reduced frequency of oscillations on boundary layer response is also examined.Design/methodology/approachA two-dimensional computational fluid dynamic code was developed to compute the effects of unsteadiness on LSB formation, transition point movement, pressure distribution and lift force over an oscillating airfoil using transport equation of intermittency accompanied by the k-ω model.FindingsThe results indicate that increasing the angle of attack over the stationary airfoil causes the LSB size to shorten, leading to a rise in wall shear stress and pressure suction peak. In unsteady cases, both three- and four-equation models are capable of capturing the experimentally measured transition point well. The transition is delayed for an unsteady boundary layer in comparison with that for a static airfoil at the same angle of attack. Increasing the unsteadiness of flow, i.e. reduced frequency, moves the transition point toward the trailing edge of the airfoil. This increment also results in lower static pressure suction peak and hence lower lift produced by the airfoil. It was also found that the fully turbulent k-ω shear–stress transport (SST) model cannot capture the so-called figure-of-eight region in lift coefficient and the employment of intermittency transport equation is essential.Practical implicationsBoundary layer transition and unsteady flow characteristics owing to airfoil motion are both important for many engineering applications including micro air vehicles as well as helicopter blade, wind turbine and aircraft maneuvers. In this paper, the accuracy of transition modeling based on intermittency transport concept and the response of boundary layer to unsteadiness are investigated.Originality/valueAs a conclusion, the contribution of this paper is to assess the ability of intermittency transport models to predict LSB and transition point movements, static pressure distribution and aerodynamic lift variations and boundary layer flow pattern over dynamic pitching airfoils with regard to oscillation frequency effects for engineering problems. http://www.deepdyve.com/assets/images/DeepDyve-Logo-lg.png Aircraft Engineering and Aerospace Technology: An International Journal Emerald Publishing

Numerical study of boundary layer transition using intermittency model

Download PDF
13 pages

Loading next page...
 
/lp/emerald-publishing/numerical-study-of-boundary-layer-transition-using-intermittency-model-uVqw8mxfEf

References (24)

Publisher
Emerald Publishing
Copyright
© Emerald Publishing Limited
ISSN
1748-8842
DOI
10.1108/aeat-05-2018-0144
Publisher site
See Article on Publisher Site

Abstract

In this paper, the applicability of shear stress transport k-ω model along with the intermittency concept has been investigated over pitching airfoils to capture the laminar separation bubble (LSB) position and the boundary layer transition movement. The effect of reduced frequency of oscillations on boundary layer response is also examined.Design/methodology/approachA two-dimensional computational fluid dynamic code was developed to compute the effects of unsteadiness on LSB formation, transition point movement, pressure distribution and lift force over an oscillating airfoil using transport equation of intermittency accompanied by the k-ω model.FindingsThe results indicate that increasing the angle of attack over the stationary airfoil causes the LSB size to shorten, leading to a rise in wall shear stress and pressure suction peak. In unsteady cases, both three- and four-equation models are capable of capturing the experimentally measured transition point well. The transition is delayed for an unsteady boundary layer in comparison with that for a static airfoil at the same angle of attack. Increasing the unsteadiness of flow, i.e. reduced frequency, moves the transition point toward the trailing edge of the airfoil. This increment also results in lower static pressure suction peak and hence lower lift produced by the airfoil. It was also found that the fully turbulent k-ω shear–stress transport (SST) model cannot capture the so-called figure-of-eight region in lift coefficient and the employment of intermittency transport equation is essential.Practical implicationsBoundary layer transition and unsteady flow characteristics owing to airfoil motion are both important for many engineering applications including micro air vehicles as well as helicopter blade, wind turbine and aircraft maneuvers. In this paper, the accuracy of transition modeling based on intermittency transport concept and the response of boundary layer to unsteadiness are investigated.Originality/valueAs a conclusion, the contribution of this paper is to assess the ability of intermittency transport models to predict LSB and transition point movements, static pressure distribution and aerodynamic lift variations and boundary layer flow pattern over dynamic pitching airfoils with regard to oscillation frequency effects for engineering problems.

Journal

Aircraft Engineering and Aerospace Technology: An International Journal – Emerald Publishing

Published: Aug 21, 2019

Keywords: Transition; Laminar separation bubble; Pitching airfoil; Intermittency

There are no references for this article.