Get 20M+ Full-Text Papers For Less Than $1.50/day. Start a 14-Day Trial for You or Your Team.

Learn More →

Mechanical Testing of Cutting Fluids

Mechanical Testing of Cutting Fluids THIS paper dealt with a very important branch of lubricant testing. Methods of field testing cutting oils have presented difficult problems since they were first used and laboratory tests are also difficult because of the many varying operating conditions during test. The author described tests for drilling and turning which are designed to evaluate cutting oils. This work emphasises the difficulties involved. The efficiency of a cutting tool is dependent mainly upon cooling and lubrication, the physical requirements of the former being known. Reduction in friction will lower the cutting forces at the tool and result in more economical cutting, but the complex nature of the cutting process does not lend itself readily to a fundamental study of these properties, for the many variables present influence the chip form on which depends the ability of the lubricant to penetrate into the cutting region. http://www.deepdyve.com/assets/images/DeepDyve-Logo-lg.png Industrial Lubrication and Tribology Emerald Publishing

Mechanical Testing of Cutting Fluids

Bingham, H.L.
Industrial Lubrication and Tribology , Volume 6 (8): 3 – Aug 1, 1954
Download PDF
3 pages

Loading next page...
 
/lp/emerald-publishing/mechanical-testing-of-cutting-fluids-iGBlY92kVW
Publisher
Emerald Publishing
Copyright
Copyright © Emerald Group Publishing Limited
ISSN
0036-8792
DOI
10.1108/eb052291
Publisher site
See Article on Publisher Site

Abstract

THIS paper dealt with a very important branch of lubricant testing. Methods of field testing cutting oils have presented difficult problems since they were first used and laboratory tests are also difficult because of the many varying operating conditions during test. The author described tests for drilling and turning which are designed to evaluate cutting oils. This work emphasises the difficulties involved. The efficiency of a cutting tool is dependent mainly upon cooling and lubrication, the physical requirements of the former being known. Reduction in friction will lower the cutting forces at the tool and result in more economical cutting, but the complex nature of the cutting process does not lend itself readily to a fundamental study of these properties, for the many variables present influence the chip form on which depends the ability of the lubricant to penetrate into the cutting region.

Journal

Industrial Lubrication and Tribology – Emerald Publishing

Published: Aug 1, 1954

There are no references for this article.