Get 20M+ Full-Text Papers For Less Than $1.50/day. Start a 14-Day Trial for You or Your Team.

Learn More →

Alternative surface finishes – options and environmental considerations

Alternative surface finishes – options and environmental considerations Printed circuit boards (PCBs) requiring component attachment, whether leaded or surface mount technology, must have the exposed copper land areas coated with a protective finish. This protective coating must not inhibit solderability and at the same time must act as a barrier for preventing the copper from oxidizing and the inevitable assembly problems that would ensue for the end‐user. Globally, the predominant surface finish in the PCB industry is hot air solder levelling (HASL). Driven by the adoption of solder mask over bare copper, HASL was developed as a reliable method of applying solder to the copper surfaces after solder mask. During HASL, a thin layer of solder is deposited onto the exposed copper by passing the boards through a hot, molten wave (or pot) of solder and subsequently blowing the excess solder from the boards using high velocity hot air. This process has been increasingly under scrutiny due to environmental and safety issues (hazardous waste, lead exposure, etc.), technological limitations (fine‐pitch device assembly) and equipment maintenance cost. This paper reviews the major alternative surface finishes being currently deployed and additionally seeks to give an overall assessment of the broader environmental aspects of such finishes. http://www.deepdyve.com/assets/images/DeepDyve-Logo-lg.png Circuit World Emerald Publishing

Alternative surface finishes – options and environmental considerations

Rod Kellner
Circuit World , Volume 30 (2): 4 – Jun 1, 2004
Download PDF
4 pages

Loading next page...
 
/lp/emerald-publishing/alternative-surface-finishes-options-and-environmental-considerations-03cbcUzEiE
Publisher
Emerald Publishing
Copyright
Copyright © 2004 Emerald Group Publishing Limited. All rights reserved.
ISSN
0305-6120
DOI
10.1108/03056120410512208
Publisher site
See Article on Publisher Site

Abstract

Printed circuit boards (PCBs) requiring component attachment, whether leaded or surface mount technology, must have the exposed copper land areas coated with a protective finish. This protective coating must not inhibit solderability and at the same time must act as a barrier for preventing the copper from oxidizing and the inevitable assembly problems that would ensue for the end‐user. Globally, the predominant surface finish in the PCB industry is hot air solder levelling (HASL). Driven by the adoption of solder mask over bare copper, HASL was developed as a reliable method of applying solder to the copper surfaces after solder mask. During HASL, a thin layer of solder is deposited onto the exposed copper by passing the boards through a hot, molten wave (or pot) of solder and subsequently blowing the excess solder from the boards using high velocity hot air. This process has been increasingly under scrutiny due to environmental and safety issues (hazardous waste, lead exposure, etc.), technological limitations (fine‐pitch device assembly) and equipment maintenance cost. This paper reviews the major alternative surface finishes being currently deployed and additionally seeks to give an overall assessment of the broader environmental aspects of such finishes.

Journal

Circuit World – Emerald Publishing

Published: Jun 1, 2004

Keywords: Printed‐circuit boards; Surface fitting; Solder

There are no references for this article.