Access the full text.
Sign up today, get unlimited access with DeepDyve Pro!
to investigate the effect of the Al plate thickness on the tensile - shear properties, namely the effect of bending stiffness of Al plates. The maximum tensile - shear loads increased with increasing Al plate ...
. Tensile strength , adhesive force and adhesiveness increased, and shear strength decreased with the delay of harvest time. In addition, the tensile strength and thickness of the laver at different harvest ...
in shear mode using a tensile tester. The thickness of the electrospun mem- brane was varied and the effect of thickness on shear adhesion was investigated. The shear adhesion strength increased when ...
- adhesion effect of the reattached film.RESULTS:The tensile and shearing test showed gelatin films ≥30 μm thick had greater tensile strength and a smaller number of film fractures, than the conventional film ...
(polyethylene) while maintaining a constant adhesive film thickness . It is shown that the ' tensile shear strength of a lap specimen is not governed by edge effects but rather by the bonded area. By using limit ...
In this paper, the shear strength of adhesively bonded single-lap joints were experimentally and numerically investigated. Based on the validated simulation, the effects of lap length, adhesive layer ...
to an increase in the ultimate tensile strength of bulk specimens almost 24% and 12% for two graphene types compared to the neat adhesive . Also, the shear strength of adhesive and hybrid lap joints incorporating ...
shear modulus, and adhesive thickness on the delamination failure are investigated. The model shows that decreasing the modulus of the coupling improves the delamination failure load; however ...
on ultimate shear shown improvement in the static and fatigue strength as tensile load (USTL) on weld-bonds of a 2-mm- thick compared to spot-welded structures besides increased dura- 6061T651 aluminium alloy ...
thickness and overlap length. Both FEM stress analyses and experimental results revealed that failure occurred around the edge zones of the overlap length due to the effect of shear stresses, while ...
Access the full text.
Sign up today, get unlimited access with DeepDyve Pro!