TY - JOUR
AU - Dültgen, P.
AB - AbstractStrip material with a thickness of 0.85 m was austempered in a suitable continuous hardening furnace for the further development of blade body steels used for thin-cutting circular and band saw blades. This work also comprised the search for a rather straightforward metallographic preparation procedure allowing for a reliable identification of the microstructure and microstructural constituents. The prepared microstructure can be revealed using Nital or Beraha and LePera etching solutions. None of the three etchants allows a reliable and reproducible distinction of the microstructural constituents of the extremely fine-grained lower bainite using light-optical techniques. Only the use of the scanning electron microscope at higher magnifications allows a reliable identification of the characteristic bainite fiber bundles. For this examination, etching with Nital is recommended.
TI - Preparation Methods for Lower Bainite after a Continuous Austempering Treatment of Thin Sheets of the Eutectoid Cold Work Steel 80CrV2 (1.2235)
JF - Practical Metallography
DO - 10.1515/pm-2021-0015
DA - 2021-04-30
UR - https://www.deepdyve.com/lp/de-gruyter/preparation-methods-for-lower-bainite-after-a-continuous-austempering-yYoDBtxqlS
SP - 204
EP - 215
VL - 58
IS - 4
DP - DeepDyve
ER -