TY - JOUR
AU - Smirnov, D A
AB - The parameters of the starter battery may degrade during its operation in the vehicle resulting in failures of the consumer units, for example, starter. It is necessary to know the principle of the battery parameters changes during its operation for the purpose of prevention of the battery fault incidence and simplification of the process of their correction. The purpose of the article is the development of the ways of simulation of various faults. This will enable to perform the extensive testing of the battery under laboratory conditions because testing on board would complicate the experiments significantly. The article proposes the ways of simulation of seven the most typical faults of the starter battery. The proposed experiments will make it possible to regulate the battery fault scale manually. This will enable to identify the output parameters of the battery under various conditions, as well as to find the critical points. Discharge of the battery up to 70, 55 and 40% of charge was simulated in the context of the article. Moreover, the results of testing of this battery with the use of discharge tester were presented. Further researches will be devoted to the identification of the battery parameters during simulation of its faults.
TI - Physical simulation of the faults of starter batteries
JO - IOP Conference Series: Materials Science and Engineering
DO - 10.1088/1757-899X/971/5/052066
DA - 2020-12-01
UR - https://www.deepdyve.com/lp/iop-publishing/physical-simulation-of-the-faults-of-starter-batteries-mO0n3Z2FZ6
SP - 052066
VL - 971
IS - 5
DP - DeepDyve
ER -