TY - JOUR
AU - Gavrilova, V.
AB - The oil film thickness under the test conditions was 8-30 ~m, the thickness of this film in the bearing on the delivery side being smaller than that in the bearing on the in- take side due to the action of higher load. The calculated and experimental data were found to be in satisfactory agreement~ The referred investigations of the parameters of sliding bearings made it possible to make a thorough assessment of their performance and to take steps to finish this in- dispensable assembly of the screw compressor for ensuring the derived reliability and durability factors. LITERATURE CITED i. P. A. Andreev,"State and propects of growth of screw compressor manufacture~" Trudy TsKTI (Io Iv Polzunov Central Scientific Research, Planning and Design Boiler and Turbine Institute), No. 127, 3-7 (1975),, 2o S~ Vo Kondratyuk, "Measurement of oil layer thickness in sliding bases," Izv. Vyssh. Uchebn. Zaved~, Mashinostr., Noo I0, 179-180 (1977)~ 3o No Sh~ Faingold, A. Ya. Reshetnikov, and M. L. Aksel'rod, "Measurement of oil gap sliding bearings of diesel engines by portable inductive transducers," Energomashinostr~ No. 5, 35-37 (1968). Vo S. Selyugin, "Inductive method of measurement of radial gaps in turbines," Energoma- shinostr., No. 9, 37-40 (1961). FEED PUMP 
TI - Feed pump operation during steam generation in the chamber past the discharge disk
JF - Chemical and Petroleum Engineering
DO - 10.1007/BF01148062
DA - 2005-01-28
UR - https://www.deepdyve.com/lp/springer-journals/feed-pump-operation-during-steam-generation-in-the-chamber-past-the-gRPVb0z0Cq
SP - 411
EP - 414
VL - 17
IS - 8
DP - DeepDyve
ER -