TY - JOUR
AU - 
AB - Atmos. Meas. Tech., 12, 4725–4731, 2019 https://doi.org/10.5194/amt-12-4725-2019 © Author(s) 2019. This work is distributed under the Creative Commons Attribution 4.0 License. Derivation of flow rate and calibration method for high-volume air samplers 1 2 Richard Hann and Mark Hermanson Department of Cybernetics, Norwegian University of Science and Technology (NTNU), Trondheim, 7491, Norway Hermanson & Associates LLC, Minneapolis, MN 55419, USA Correspondence: Richard Hann (richard.hann@ntnu.no) Received: 6 September 2018 – Discussion started: 18 October 2018 Revised: 27 June 2019 – Accepted: 13 August 2019 – Published: 5 September 2019 Abstract. Sampling the atmosphere to analyze contaminants rinated biphenyl released to specific amounts of air had to is different from other environmental matrices because mea- be known to identify the amount of toxic substance inhaled suring the volume of air collected requires a mechanical by the test organism. The air flow was measured by an ori- flow-through device to draw the air and measure its flow fice calibrator that enabled the volume of air to be known rate. The device used must have the capability of concen- over a certain time period. Although the orifice calibrator is trating the analytes of interest onto a different substrate be- mentioned in this report, 
TI - Derivation of flow rate and calibration method for high-volume air samplers
JF - Atmospheric Measurement Techniques
DO - 10.5194/amt-12-4725-2019
DA - 2019-09-05
UR - https://www.deepdyve.com/lp/unpaywall/derivation-of-flow-rate-and-calibration-method-for-high-volume-air-M0Sp0dZ0d5
DP - DeepDyve
ER -