TY - JOUR
AU1 - Danilov, B.
AB - (UDC 669.1.004.2) B. A. Danilov Novolipetsk Metalhrgical Plant Translated from Metallurg, No. 12, p. 16, December, 1964 During operation of centrifugal pumps for blast-furnace gas type 700 from the V. I. Lenin Machine Construction Plant at Nevski, escape of gas to the ma- chine room occurs through the terminal seal of the shaft which causes an in- crease in the concentration of carbon monoxide in the air. The necessary hermeticity in a pump of the indicated type should be pro- vided by labyrinth and terminal seals of the shaft. However, during use, the seal ring for the labyrinth seal often wears out. Especially rapid wear occurs when working with dusty blast-furnace gas; due to uneven deposition of dust on the blades of the working wheel, its initial balance is destroyed. A large amount of gas begins to penetrate to the terminal seal which consists of a vane and girdle with two seal rings, and it cannot provide the necessary hermeticity. At several metallurgical plants a suction hood is installed above the ter- minal seal of the pump shaft. The escaping gas together with air is sucked off and released to the atmosphere. This method gives positive results, but requires 
TI - No carbon monoxide detected
JF - Metallurgist
DO - 10.1007/BF00739541
DA - 2004-11-19
UR - https://www.deepdyve.com/lp/springer-journals/no-carbon-monoxide-detected-FrffR00O0y
SP - 658
EP - 658
VL - 8
IS - 12
DP - DeepDyve
ER -