TY - JOUR
AU - Merenkov, A.
AB - Rolled and Tubular Products Cand. Tech. Sci. E. R. Shor and Engineer A. I. Merenkov All-Union Scientific Research Institute for the Metalworking and Machinery Industry Translated from Metallurg, No. 5, pp. 26-29, May, 1960 The most progressive and efficient method of pro- 0.20 mm) and narrow (10- i5 mm)flats, but presently shaped metal from thick and wide sheets is used for ducing shapes, especially of thin-wailed and complex form, is the method of bending the fiat or sheet material the frames and bodies of buses, trucks and light auto- on special bending mills; this method is based on succes- mobiles, spars, wheel rims, dumps of dump trucks, parts for trailers, etc. sive changes in the configuration of the cross section while passing it through counter-rotating pairs of roils which, Bent shapes are widely used in agricultural machinery due to the special pass grooves cut in them, give the (linings, frames, brackets, supports, etc.). The annual demand for these just in this field in the USSR for 1960 bloom the final cross sectional shape. is approximately 30- 35,000 tons. The production of shapes on bending mills opens wide possibilities for producing shapes of complex con- Bent shapes are widely used 
TI - The production of bent shapes
JF - Metallurgist
DO - 10.1007/BF00742334
DA - 2004-11-19
UR - https://www.deepdyve.com/lp/springer-journals/the-production-of-bent-shapes-0lEE9MVfnl
SP - 203
EP - 205
VL - 4
IS - 5
DP - DeepDyve
ER -