TY - JOUR
AU1 - Drozd, V.
AU2 - Prikhod'ko, I.
AB - V. G. Drozd and I. F. Prikhod'ko VNtlMETMASh (All-Union Scientific Research Institute of Metalworking and Machinery) Translated from Metallurg, No. 5, pp. 31-34, May, 1960 in the production of steel sections, continuous mills effected by the raising mechanism of the inner-housing. are very widely used, with vertically disposed stands, This consists of two screw gears joined below to the which cut out the process of tilting the metal being outer-housing, and two pairs of female screws mounted in the bore of the housing. The screw gears are connected rolled. by a toothed coupling and rotated from an electric motor. On section mills two types of vertical stand are used: a) rolls driven from above; b) rolls driven from The mechanism for raising the inner housing is also de- signed for roll-changing: the spindles are raised into their below. highest position and held there by special locking devices; In working stands with drive from below, roll-chang- then the framework is withdrawn and installed on the ing is made considerably easier, but access to the drive mechanism is difficult, and moreover, the housing has slide-block of the roll-changing mechanism. The roll-changing mechanism consists of slides to be very compact with gear 
TI - New working stands for section-mills
JF - Metallurgist
DO - 10.1007/BF00742336
DA - 2004-11-19
UR - https://www.deepdyve.com/lp/springer-journals/new-working-stands-for-section-mills-0M7Kg4CJ2D
SP - 208
EP - 211
VL - 4
IS - 5
DP - DeepDyve
ER -