Select All | Select None
Login failed. Please try again.
Forgot your password?
Log in with Facebook
Log in with Google
You can now keep track of new articles from Metal Science and Heat Treatment on your personalized homepage!
In the operation of the power equipment of steam power plants the steam pipe bends can be damaged at a temperature exceeding 500°C. The presence of creep pores (especially pore chains) in the metal of a bend operating for a long time indicates that the service life of the bend has been...
The quality of the metal of rotor turbines and generators is one of the main factors determining their reliability and service life. It is important not only to choose correctly the grade of the steel but also the process of its production. The results of a study of two kinds of defect observed...
The methods of scanning electron microscopy, local electron probe analysis, and x-ray diffraction analysis are used for studying the morphology and local composition of grains in melt-textured long specimens of superconductors based of barium-yttrium cuprate and fabricated by the method of zone...
The strength and the operational properties of low-alloy thick-sheet steels is increased by heat treatment in the line of the mill with the use of the rolling or furnace heat. The present work concerns the special features of structure formation and the mechanical properties of rolled stock from...
It is important to devote maximum attention to the heat treatment of temperable high-strength weldable steels (σ 0.2 ≥700 MPa) in which the expensive alloying elements (Cr, Ni, Mo, etc.) are partially or fully replaced by microadditives (V, Ti, etc.). The present paper concerns the effect of...
In many cases the plastic properties and brittle fracture strength of industrial semiproducts from high-strength steels are caused by their structural inhomogeneity. The structural inhomogeneity of such steels can be diminished and the plastic characteristics improved by conducting a preliminary...
The technological possbilities of directed crystalization are broad and make it possible to manufacture castings from high-temperature alloys with various sets of properties. The present work is devoted to the possibilities of intensifying directed crystallization of the Ni 3 Al intermetallic...
The interest in cast tools has grown for several reasons. In particular, the casting process provides effective utilization of various kinds of waste high-speed steels. However, successful operation of cast tools is possible only if we solve the problem of the elevated brittleness of cast metal....
The results of a study of the structure of submicrocrystalline metals conducted with the help of transmission electron microscopy, Mössbauer spectroscopy, and calorimetric measurements are presented. The effect of the special features of the microstructure on the amplitude and temperature...
results per page
Save this article to read later. You can see your Read Later on your DeepDyve homepage.
To save an article, log in first, or sign up for a DeepDyve account if you don't already have one.
Sign Up Log In
To subscribe to email alerts, please log in first, or sign up for a DeepDyve account if you don't already have one.
Read and print from thousands of top scholarly journals.
Sign up with Facebook
Sign up with Google
Already have an account? Log in
To get new article updates from a journal on your personalized homepage, please log in first, or sign up for a DeepDyve account if you don't already have one.