Select All | Select None
Login failed. Please try again.
Forgot your password?
Log in with Facebook
Log in with Google
You can now keep track of new articles from Journal of Mechanical Science and Technology on your personalized homepage!
Flight vehicles such as wheel wells and bomb bays have many cavities. The flow around a cavity is characterized as an unsteady flow because of the formation and dissipation of vortices brought about by the interaction between the free stream shear layer and the internal flow of the cavity. The...
This paper reports the design of a novel twisting-type micromirror actuation system. The actuating mechanism for driving the micromirror combines two paralleled bimorph actuators bending in opposite directions for rotational control of the micromirror. Each actuator is structured by gold and...
Loop heat pipes often experience start-up problems especially under low thermal loads. A bypass line was installed between the evaporator and the liquid reservoir to alleviate the difficulties associated with start-up of a loop heat pipe with flat evaporator. The evaporator and condenser had...
In this study, CFD analysis of air-heating vaporizers was conducted. A longitudinally finned vertical pipe was used to represent the air-heating vaporizer in the CFD model. Nitrogen gas was used as the working fluid inside the vertical pipe, and it was made to flow upward. Ambient air, which was...
Breakup and spray formation by impinging liquid jets introduced into a low-speed cross-flow are experimentally investigated. Effects of the cross-flows on the macroscopic and microscopic spray parameters are optically measured in terms of jet Weber number and liquid-to-gas momentum ratio. The...
The characteristics of NOx emissions in pure hydrogen nonpremixed jet flames with coaxial air are analyzed numerically for a wide range of coaxial air conditions. Among the models tested in simple nonpremixed jet flame, the one-half power scaling law could be reproduced only by the Model C using...
Three types of flow passage structure of a total heat exchanger (perforated type, slit type, and embossed and perforated type) are studied to enhance the heat exchange performance of a heat recovery ventilation system (total heat exchanger). The perforated type has four punched rows of 6mm holes...
We examine the applicability of three different non-Newtonian constitutive models (power-law, Casson, and Herschel-Bulkley models) to the determination of blood viscosity and yield stress with a scanning capillary-tube rheometer. For a Newtonian fluid (distilled water), all three models produced...
In-line digital particle holography is applied to measure the characteristics of spray droplets. Common reconstruction methods were considered and the best one was selected. Several important parameters at the time of hologram recording, such as the object distance and the region of laser beam...
Spray characteristics of an injector employed in the 5 Newton-class of liquid-propellant thruster are addressed with an evolutionary feature of droplets. Information for the droplets is obtained through Dual-mode phase Doppler anemometry (DPDA) measurement in terms of the velocity, diameter,...
results per page
Save this article to read later. You can see your Read Later on your DeepDyve homepage.
To save an article, log in first, or sign up for a DeepDyve account if you don't already have one.
Sign Up Log In
To subscribe to email alerts, please log in first, or sign up for a DeepDyve account if you don't already have one.
Read and print from thousands of top scholarly journals.
Sign up with Facebook
Sign up with Google
Already have an account? Log in
To get new article updates from a journal on your personalized homepage, please log in first, or sign up for a DeepDyve account if you don't already have one.