Access the full text.
Sign up today, get unlimited access with DeepDyve Pro!
of the contact electrical resistivity of the interface between two unbonded laminae of a continuous carbon fiber thermoplastic (nylon-6) matrix composite during heating provides a method of thermal analysis ...
. The results show that the basalt fiber -reinforced thermoplastic epoxy polymer has good interface properties between the fiber and new thermoplastic epoxy, which results in high tensile strength and ductility ...
due to the decrease in lamellar thickness and the increase in crystalline disorder. The results were affected mainly by the lack of adhesion at the interface between the matrix and fibers ...
A carbon fiber reinforced thermoplastic (CFRTP) was irradiated with a high energy electron-beam. As a result, the tensile strength of high-density polyethylene (HDPE)-based CFRTPs was significantly ...
modes of fibers , matrices, and fiber /matrix interfaces in the open-hole structures of thermoplastic and thermosetting composites under compressive load. The differences between thermoplastic ...
interface bond between polymer and asbestos fibers . INTRODUCTION Although glass fiber is still the most widely used reinforcing filler for thermoplastics , a wide range of alternative fillers has been proposed ...
The resin matrix and CF fibers itself of CF/PEEK composites exhibit surface inertness, resulting in poor interface bonding between CF and PEEK matrix. This phenomenon seriously affects the mechanical ...
In the present work, a single‐ fiber pullout test was used to study the interface /interphase between various fibers and low‐density polyethylene (LDPE) and between glass fibers and a range of other ...
of polyphenylence sulfide at four environment temperature. The results indicate the increasing value of adsorbed heat improves water-resistant ability and interface bond force between the carbon fiber and matrix ...
modeling (FDM) process.Design/methodology/approachThe strength of these materials is highly dependent on the interface that forms between the continuous fiber and the plastic. A cohesive zone model ...
Access the full text.
Sign up today, get unlimited access with DeepDyve Pro!